If you are judging by the statcards I made, then some of the information there is a little outdated and the penetration numbers for the 80 mm gun I just estimated, and it seems they are overestimates. I will have to remake those statcards later. For a more accurate idea of how it would perform, I suggest checking out the suggestion for the 44M Tas. I believe with the 75 mm gun it could be 4.7-5.0, and with the 80 mm gun it could be 5.3-5.7.
play AMC.34 YR then and you’ll see what’s the worst vehicle. I didn’t have a problem using Csaba. It’s a very good vehicle.
3 Likes
Exactly, the AMC.34 YR can penetrate less armour than the Csaba, shoots much slower (nearly 8s reload time, it shoots 5x slower than the Csaba), has much worse shell velocity, only 2 crew thus is an easy one shot, and is way slower, especially in reverse.
The Csaba is really not that bad. My only problem with it is the ghost shells that often make half my clip vanish, but if that got fixed then my only problem would be the poor post-pen damage, but with some careful aiming and the good rate of fire, this isn’t a big problem. For a 1.0 armoured car, it’s perfectly fine.
1 Like
What I have experienced is that the tnt is too low with only 1g, which doesnt even pepper the enemy crew, so it feels like a ghost shell.
1g of TNT? It has 2.38g of TNT. It does pepper the enemy crew, but unfortunately only peppers the enemy crew.
My bad, I remembered the L3’s values
1 Like
There was a problem in the production of 75 mm thick armor plates for a while since Hungary lacked the industrial capacity for that.
For a while, a 75 mm armor plate was possible only by placing three 25 mm thick armor plates together. Because of that, the first few Zrínyi assault guns had that kind of “sandwiched” armor. However, in October 1943 a new 75 mm thick Ajax armor plate was made. This armor plate had an acceptable 78-90 kg/mm2 (764.9187-882.5985 MPa) tensile strength and provided better protection against 7.5 cm caliber guns than the 50 mm thick armor plates.
The 75 mm Ajax armor plate’s composition: C 0,32-0,40% - Mn 0,9-1,2% - Cr 1-1,7% - Si max. 0,4% - Va max. 0,2% - Ti max. 0,15%. From that time on the Zrínyi assault guns all used this type of Ajax armor for their frontal armor plates. A serial 43.M Turán and 44.M Zrínyi probably would had this type of armor too.
2 Likes
Falls under the new partial prototype category Gaijin added, so it can still be added.
2 Likes