did the devs say something about changing multipath?
That they won’t
1 Like
bruh
McAir chef of aerodynamics quote :
Unique feature of the F-15 propulsion system is the movable first ramp of the inlet. Some of the details of this feature are indicated. The movable ramp is relatively large and is far enough forward of the center of gravity to have a significant effect on longitudinal stability and control characteristics and trim drag.
I have reviewed the articles on measurements in wind and water tunnels :
Water tunnel measurements showed that dropping the upper surface of the inlet resulted in a delay in the flow separation along the hull by about 5 degrees of angle of attack
Without this mechanization, the F-15 would have been less maneuverable and less powerful.
I don’t want F-15A Baz carry AIM-9M & AIM-7M like F-15C Baz Meshupar (Improved Baz).
I need gaijin mod remove AIM-9M from F-15A Baz and AIM-7F Sparrow swap AIM-7M
Air National Guard’s 2017 priorities document
Can’t find it
https://community.gaijin.net/issues/p/warthunder/i/HGnvdjS5pu9k
Denied.
I guess the PW220 F15C will just be fatter& slower F15A with the same fantasy radar coming straight out of yefim gordon’s fairytales.
7 Likes
For some reason heavier than F-15J Msip which undergone same modification.
Dunno about f15j msip but an F15C with msip(+ pilot, oil and unusable fuel) is 29,500lbs. But don’t sweat if its not exact. There is a max 500lbs difference between the same plane in the same manual and difference at difference dates. Though I think the weight in the appendixs(performance charts) is given with ammunition as its ~500lbs and the weight given in the manual is 500lbs less
We’re back baby.
6 Likes
Good compensation for being heavy.
What about BOL?
Gaijin not increase max thrust & afterburner thrust of Pratt & Whitney F-100-PW-220 engine on F-15C like Ishikawajima-Harima F100-220E engine on F-15J(M) ?
Stock and spaded
No spesific information for that, assuming it will be on final configuration.
PW-220E motors have slightly higher thrust than PW-220 motors
isnt 220E is 100 upgraded to be 220 equvalent?