hmm ill dm you
This may be the increased thickness
Dman it man, i told you get clog :/
Maybe I’d hope the array is a little thicker downward reducing the area that is unarmoured on the LFP.
The current array already extends further than that;
does anyone know if it has spall liners in the turret
The new one
Bit early to know that, but I doubt the protection will be dropped from the standard CR2. The only reason the CR3TD in game doesn’t is the CR2 LEP the turret it is based on didn’t have them in. But as its a TD its expected some stuff is missing.
Yeah as this is one we got yesterday is meant to show how it will be when its adopted so it properly does have the liners
Yeah its taller which will help somewhat but the LOS is still roughly the same with the addon plate. (as far as I can see ofcourse).
It’s better than nothing. Has the hull also changed the armor？
Of course there is little doubt there haha, I’m unsure if they increased the protection, its possible newer composites have been used. But little evidence of that yet.
I can’t wait to see this tank in WT anymore
Newer composites would of been used as we know they have already signed off on new armour
1 Like
If Gaijin end up implementing this version with the new armour packs it would be illogical not to have an increase in protection - especially given there’s no obvious weight savings mentioned as a programme goal and the chally 2s hull array isn’t exact up to date.
did i understood wrong on the devblog? when they say the bug reports that have allredy been fixed or will be fixed in the future the spall liner is there
It was added with the information that were at that moment, Fireball recently got photos of spall liner on the hull sides
so youre saying they accepted the cr3TD to have spall liners on the turret but not the hull?
no, they accepted 3TD havin at the ufp, as it was unchanged to the Cr2, Turret does not have spall liner. Now it will get on the hull sides and lfp
1 Like
Hull side spall liner
What a good day
Denied due to lack of primary souce ;)