yeah… a whopping 0.6 seconds faster reload and with a shell with 6mm more pen then the Pz.IV at 4.0… so much OP.
I still need to spade my Chi-Ri and figure out how to not suck, but from what little experience I have with it, it’s seems like a very situational vehicle. The reload speed only occasionally comes into play. It’s hard to fully take advantage of it when many vehicles have much better turret traverse speed and will get the first shot off, usually going through since the armor’s no good.
I just can’t say that its advantages over the Chi-To warrant being a whole BR higher, even if it got the engine power corrected to 700 ps.
Yeah i also think the M4A3 76 is a very good tank but why is the M4A2 5.3 and M4A3 5.7 when they are nearly indentical
Tbf i prefer the soviets way more, the T-34-85 are way better than this tank and same for the IS-1, the chi ri is slow, has the firepower of a panzer iv, mid armour and the only good thing about this tank is the autoloader
Yeah but i dont think one round should make this M41 in particular .3 br higher especially when it starts with HVAP stock
Stock shells do not matter in the slightest. Besides, it not really fair to the Japanese and American M41s to be at the same BR as the objectively better Lekpz M41.
I think you’d understand if you actually owned the lekpz m41, appart from the heat, pretty much nothing else changes, and this heat is worse than the m51 because its pretty much has no spall and half the pen so you would probably still use the apds instead, and yes stock shell does matter, while you have to grind one with ap that is meh but not that bad if you aim for the ammo and flank, for the other one you have an apcr that even if you aim for the ammo is gonna just put it in orange and because its apcr it will also shatter often and do basically no spall dammage (atleast in game)
I own the T92, and having HEATFS is a pretty considerable step-up from the very inconsistent early sabot.
Yeah but the T92 is way smaller which makes it really good for this unlike the M41 which is as big as a medium-some heavy tank and that is because it only has enough armor for aphe to fuse, the only better thing it’s got compared to the T92 is the fact that it’s 30kmh faster but that’s not very reliable because once you get to 50kmh, your acceleration gets very slow and i think the sabot is way more consistent than heat fs. Also correct me if i’m wrong but i think the T92 also reloads faster and has a better hp/ton ratio
The T92 is two steps above the M41A1, so the Lekpz M41A1 is perfect to sit between the two.
I disagree here. HEAT shells imo are way more consistent. Especially because they have perfect angle pen instead of shattering. On tanks with a choice between HEAT and APDS that are roughly equal, like T-54s and Type 74c, I will always pick HEAT unless it has really slow velocity.
A similar situation is the Vijayanta vs. Vickers mk.1. They are 1 step apart and the only difference is HEAT-FS or not