Have you got keep values for disabled axis enabled? (i’m on xbox might be different names)
Otherwise thats some sorta stealth nerf to Britain’s only decent dogfighter…
Have you got keep values for disabled axis enabled? (i’m on xbox might be different names)
Otherwise thats some sorta stealth nerf to Britain’s only decent dogfighter…
Let me check, but untill situation above i was able to do all kind of manouvers while keeping nozzle at any %
For xbox theres a toggle in the thrust vectoring portion of controls and it means you have to manually keep the nozzles vectored unless you enable it in which case when you let go it will stay at the same angle that you last set it to.
Might be something similar to that for PC? If not then I got no idea hopefully its just a bug.
I had it off, but even after turning it onn it does the same lemme record it
I think its relative control, mine defaulted on after an update. try Switching that off
Nope, it does that nozze sets on 50 and you can make it go 0 or 100 when you hold the button
It seems to be tied to speed
It starts over 200kph, when nozzles end at 92%
Either a weird feature or a even weirder bug
It seems that when you take off normally it does not trigger
So a very weird bug i guess??? It should not affect anyone, unless it will also trigger during a dogfight, then it will be annoying.
I don’t seem to be able to replicate it, double check you’ve not got an extra device plugged/disconnect and reconnect your imput devices?
Keyboard mouse only, nothing else ever
I just resetted the game and it is the same.I have no idea what causes this
What happens if you unbind the thrust vector controls?
i will check
I get an error that TVC is not assigned and it snaps to 50%
After setting them back up limit is still there
TVC not assigned error is fine. I get half a dozen of those warnings all the time. It snapping to 50% is strange I think
I used quick control remove, so it probably turned relative controll off
Still after setting them up again and setting relative controll to on it is still here
Manula controll remove test in progress
I just tried it myself (deleted my bindings for it using that button) and then it sets to 0% and doesnt move. So its almost as if you’ve got a binding/settings or something changing it. Its very wierd
tried it as well, doesnt happen to me