Swedish 40 mm slpprj 90 LK / slpprj 01 LK – Penetration investigation
Introduction
I wanted to look into the penetration values of the Swedish 40 mm slpprj 90 LK and slpprj 01 LK, since there appears to be a significant difference in their penetrator construction.
After finding Swedish ammunition documentation, I measured both projectiles using available photographs and compared their dimensions and muzzle velocities using a penetration calculator.
There is also an interesting Bofors document mentioning a potential 25% improvement in penetration performance for the 40 mm APFSDS-T, which makes this comparison worth investigating.
1. Official specifications
Swedish ammunition documentation provides the following information:
| Specification | slpprj 90 LK | slpprj 01 LK
| Designation | M4040-406610 | M4040-416610 |
| Muzzle velocity | 1,465 m/s | 1,495 m/s |
| Projectile weight | 0.50 kg | 0.50 kg |
The m/01 has a 30 m/s higher muzzle velocity.
2. Penetrator construction and measurements
The two projectiles do not use the same penetrator construction.
The slpprj 90 LK does not have a monolithic tungsten penetrator, while the slpprj 01 LK uses a monolithic tungsten penetrator.
Measurements taken from the available projectile photographs:
| Measurement | slpprj 90 LK | slpprj 01 LK |
|---|---|---|
| Measured penetrator length | 144.38 mm | 187.97 mm |
| Diameter | 10.3 mm | 10.3 mm |
The m/01 has approximately 30.2% greater measured penetrator length.
This is a substantial difference, especially considering that both projectiles have the same documented total projectile weight of 0.50 kg.
3. Penetration calculator results
I entered the measured dimensions and documented velocities into a tungsten penetration calculator.
The parameters used were:
- Target material: RHA
- Target density: 7,850 kg/m³
- Target hardness: 260 BHN
- Obliquity: 0°
- Penetrator diameter: 10.3 mm
- Tungsten density: 17,500 kg/m³
These were the results:


A close result to bofors expected 25% performance increase being a performance increase of about 23.86%
Resulting in penetration values of
slpprj m/90: 132mm
slpprj m/01: 163.5 or 164


