Radar is not working

After turning off the radar, the radar does not move(mode TWS),how can i fix this?HELP

Bind the reset to boresight key.

3 Likes

Any chance there could be an option to have it do it automatically?

Its annoying to have yet another key bind because they decided to make this change.

1 Like

How did you reset it before the update? if it was by turning the radar off and on, you can use the same key for 2 keybinds and it should work as before

you didnt, it automatically did this. Gaijin added this keybind without telling anyone and it was so annoying they actually forced me to go and map manual elevation controls (which are great btw)

I always used manual controls so I don’t know how it reset previously, OP says after turning radar off so for his case he can use the same off/on key for boresight reset

The current behaviour is intentional. I will be chatting to a dev about it, but I suspect it won’t be possible.

  • As it is now possible to move the radar scan zone horizontally in TWS mode with cyclic target switching turned on, the values set by the player for the horizontal radar target cue control axis and the radar tilt control axis are now in sync with the automatic changes in the scan zone’s location due to tracking. Just as they were in sync when cyclic target switching was turned off. Due to this, now when the target track has been lost in the cyclic target switching mode, the scan zone behavior is the same as when the option is turned off — the scan zone doesn’t recenter and stays oriented to where the target has been lost.

then give us a switch
i find this behaviour to be unacceptable

1 Like

Do this, I was simply caught off guard and this is annoying because sometimes I forget that now I have to keep checking the radar every second

this has caught me off guard and made things so much more laborious
i would love if they made it toggleable

I recommend binding the reset boresight to either turn radar/irst on/off or switch between radar/irst. its fine when its like that.