TYPE: trawler/Minesweeper
OLD NAME: Ex Aria, Ex Maastrom II, Ex Zaanstroom VI
OWNER: B. Ramsler, Lowestoft. UK.
BUILDING SITE: Gebr. Boot. Leiderdorp, Holland
LAUNCHED: 1916
REQUISITIONED: 11.1939
IN NORWEGIAN COMMAND: 15.10.1940 - 28.11.1944
WAR OPERATIONAL: 26.10.1940
ARMAMENT
Spoiler
-
1x 20mm Oerlikon Cannon
-Placement: uncertain -
2x1 12.7x99mm Colt Browning MG/52
-Cooling system: water cooled
-Placement: uncertain -
Minesweep
-Sweep type: LL Sweep
TECHNICAL DATA
Displacement: 148 Gross tonnage
Length: 31.12 Meter
Width: 6.30 Meter
Depth: 2.89 Meter
MACHINERY
1x Triple expansion steam eigne
Power: (not known) Indicated Horse Powers
Speed: not known
CREW
Estimated crew: 17 Men
HISTORY
Alcmaria was built by Gebr. Boot. Leiderdorp, in Holland and launched in 1916. This was the first vessel the Royal Norwegian Navy took over in Britain during the Second World War. the ship was part of 1 Minesweeper Division in Dundee and served there from 01/09/1942 to 28/11/1944, when the ship was laid up in Burntisland, Firth of Forth. The ship was then returned to the previous owner who then used it for a few years, before in 1950 it was sold to Dalby Steam Fishing Co. Ltd. In 1957 the ship was scrapped in England.
The Norwegian Navy’s previous experience in demining was only neutralizing drift mines during and after the First World War. These were isolated cases, because no minefields had been laid out in Norwegian territory. It was not until the early thirties that it was realized that this could become relevant. It was therefore decided to equip six decommissioned Class 2 torpedo boats as combined guard boats and minesweepers. The torpedo guns of these vessels were taken ashore, and on a platform aft an arrangement was set up for Oropesa sweep. Incidentally, there is very little information about the equipment on these vessels. The Oropesa sweep was developed by the Royal Navy during the First World War and was named after the trawler Oropesa which first tried this type of sweep.
The Oropesa sweep, or O sweep as it is also called, consists of a cable or wire that the vessel releases. An otter is attached to the end of the cable, which causes the cable to pull outwards from the vessel. To mark where the otter is, there is a float on the surface, called a Paravan. Along the cable there are knives that will cut the anchoring of any mines so that they float up and can be neutralized. Another otter is attached to the inner side of the vessel, so that the sweep cable cuts into the water. The system is the same as on a trawl. The O-sweep, which is operated by one vessel, was a necessary further development of the English A-sweep. This consisted of a cable, pulled between two or more vessels. During an attack, it was very difficult to maneuver with the A-sweep in the sea. The growing threat of war and thus the danger of minelaying in Norwegian waters meant that, in addition to the rebuilding of the 2. kl. torpedo boats, it was decided to build two minesweepers. These, OTRA and RAUMA, were built at Akers mech. Workshop and were completely new and fully equipped when Great Britain announced that they had laid mines at Stad, Hustadvika and Landegode north of Bodø in April 1940. OTRA and RAUMA were in Horten and had received orders to go to Western Norway to clear the minefields, but was instead involved in the fighting at Horten harbor after the German attack on 9 April. OTRA was, following reports of foreign warships in the Oslofjord, sent out to observe and was able to 04.10 report that these vessels were German. RAUMA joined OLAV TRYGGVASON in battle with the German Raumboot R.17 and R.27 at Horten harbour. R.27 fired at RAUMA and badly damaged the vessel. The Chief, Itn. I. K. Winsnes, and one deckhand was killed and six others wounded, OTRA became the Germans’ prey at the quay at Filtvet, was named TOGO and was used as a guard boat until the navy got it back in 1947. Then OTRA was converted into a training vessel for minelaying.
It was after the rebuilding of the guard boats Bjerk, Syrian, Børtind, Nordhav II, Thorodd and Hval V that the navy got to try its hand at minesweeping duty in Great Britain. These were the vessels that made it over to Great Britain after the fighting in Norway ceased in June 1940. In addition to these, the navy took over its first vessel from the Roy Navy. It was the trawler ALCMARIA, equipped as a minesweeper and under Norwegian command from 15 October 1940 to 28 November 1944. The next minesweeper taken over from the Royal Navy was actually Norwegian. The whaleboat POLAR VI was requisitioned by the Royal Navy as early as March 1940 and transferred to the navy in February 1941. The minesweepers were first stationed in harbor towns on the east and north coast of Scotland. Later, it became most practical to gather the Norwegian minesweepers in a separate Norwegian minesweeper division, which had its station in Dundee.
ALBUM
Spoiler
SOURCES
Spoiler
Nasjonalbiblioteket
Redirecting...
Norske Marinefartøy – Bodoni Forlag
Leselystig 39: Modeller som forteller – Norsk Marinehistorie | Polar Coordinate
Primary source: Nasjonalbiblioteket
- Yes
- No