once again, spaa is being left behind. this is getting rediculous.
no shell representation for spaa’s!!!
also, wrong shell representation for unusual weaponry. that piece of armor right there, should literally be blasted away.
That’s for all small caliber automatic gun weapons, not just SPAA.
discriminatiòn! 40mm should not be considered small caliber. even 20mm.
no IFVs either.
So either its not coming, or they havent yet figured out how to display “the belts”.
“37mm is not that small babe, its average, I swear!”
I think the ammo doesn’t show for autoloaders, it’s not necessarily based on caliber.
Too small to be noticeable. A 40mm dart would be invisible, they’re only about 1cm in diameter, which if you have normal sized hands is about the width of your thumb.
Even 20mm auto cannons (RH202’s like that of the Marder 1A3 and Wiesel) are still very small. The entire round is smaller than a beer bottle, casing and all. The bullet itself is smaller than the neck of the bottle too, making it almost impossible to see.
I do think they could add ‘Ammunition cans’ that’s have the rounds sitting upright next to the can to be seen easier, or like in some real life cases, the round is bright orange to be see.
Technically wrong? Think of the PG-9 of the BMP-1 with the semi-autoloader, or the 125mm darts of the T-72 and T-64.
1 Like
id go with strip of ammo belt showing entire cartridge
Yeah, I was thinking of the same thing, just without links. But that would work too. Aside from single rounds, like the Ostwind and Bofors 40mm’s.
Gaijin hasnt implemented a display for belt or clip ammo yet
Huh, didn’t think of those, so then probably autoloader below a certain caliber then.
They’re also not showing autoloading single shells for lower caliber either, like the CV9040 versions.
Even tanks without ‘auto loaders’ or belt-linked ammo don’t have them, like the CV 90 which isn’t technically auto loaded, it’s clip fed.
how is this discrimination?
1 Like
The CV9040’s are magazine fed through an autoloader though. (it’s just that the auto loader isn’t modeled in the x-ray)
Timestamped to 1:50 :
It shouldn’t be there it should be a pile of dust.
That’s really funny XD