Challenger 2 MBT - Technical data and Discussion (Part 2)

its been applied but the change isnt huge but i can notice it

It wasn’t in the patch notes…

well its been applied cause the reverse speed is 38kmh now

https://community.gaijin.net/issues/p/warthunder/i/d1OZ86M9Mkau

has been applied

2 Likes

did they add a thing to the back of the model aswell on the TES

Honestly the mobile don’t even feel that different turning is still a chore

Sometimes it also gives efficiency on BN

1 Like

It should feel a little bit different… because it’s gotten worse again:

Luckily I saved the data from older patches so that I have a fully fleshed out comparison sheet between the different time periods.

3 Likes

i wish i was surprised by this

1 Like

While the acceleration is a bit slower, it does seem to lose less speed when turning due to the inertia changes

I hope they start fixing some of the spall liners on Western IFV’s and MBT’s.

Fixing them, or just straight up adding them at all?

Last I checked there’s a few dozen its missing on.

3 Likes

well the challenger leclerc i know are missing them but the merkava ariete and more are probably missing them to

1 Like

I was about to mention the warrior after reading this, but that thing needs a whole remodel and rework. the current model is all kinds of messed up.

1 Like

Sometimes IRST can help with Spikes if you want to save APS and smoke)

1 Like

i like you a lot.

Ideal condition, yes

Locally useful tools also sometimes help and make battles a little more interesting.

Previously, I ignored smoke shells, but when I found myself in a situation where I needed to blind players in good positions who can’t be shot at easily, I regretted not taking them.
As the number of battles on the Cr2 increased, so did the number of such situations, and over time, I stopped considering these shells to be an absolute burden.

2 Likes

Thermals can see through smoke shells though?

No. Only through engine smoke