show cr3 also
no and no
Can someone post screenshot of the new mantlet xray, don’t have a computer with me. Probably you devil
jesus, how is it possible to be so bad at modeling?
1 Like
How thick is the mantlet?
No I mean rha thickness of the mantlet face
a lot of bug
238ke it is bug
It worse in some places…. Just above and bellow the gun it goes as low as 150mm ke and even 121mm near the top…. And the romor-a are still different
it is very good, the mantlet ke is 570
30+30+60+400
in single spots, mostly it is betewwn 400 and 100
1 Like
Are these the final models or is this still WIP?
final, untill we spam reports again
5 Likes
can someone see if the holes in the turret cheecks are still there?
the vertical bar right next to the mantlet
Jesus Christ it gets worse. I think it may be bugs but the TES side is still aluminium but I think the tell here is that they reverted the change to the lower armour on the TES as its back to “composite” instead of its 40mm and 60mm rha which they themselves proved? So I’m a little stumped as it what’s going on with the challenger tbh.