brimstone i think
1 Like
brimstone, its the challenger 2 streetfighter, rather weird tank tbh
1 Like
We need to hit Part 3 before they’ll do another dev blog
dummy brimstone. it’s on the Streetfighter II demonstrator, which is was developed by crews, hence all the stuff taped on it
1 Like
(1:20)
1 Like
Thanks all
1 Like
Would love to, but i lost the motivation after what they did
1 Like
small change
Huh, does back plate reach behind it?
no
Yes?
1 Like
my fault
Good, so its protection can be considered correct (for what we have now)
Too bad neither VARMA nor ASPRO are fixed
7 Likes
Need part 4 for that
1 Like
oh ffs, cant even fix it properly. so now its composite instead of the already accepted 40mm+60mm rha with air gap…
Is this a buff or a nerf?
Buff
1 Like
correct? has some other changes happened whilst ive been away as i thought the ke protection and ce protection was still far from even on par with what it should be. as it still cant defend against 25mm from the correct angle and the ce is still only 500mm when it could be as high as 1000mm at a rough estimate… and this is all including the backing plate and the challengers side armour which we all know shouldn’t be involved in the protection levels.
or were you only mentioning sides bellow the bricks, if so then sorry.
Yes i mean the brick bellow. The brocks are called VARMA in Cr 1 mk3, Cr 2 with 2E and in Cr 2 2F. In TES and OES they are called ASPRO-HMT
i love the naming of our armour… one word could mean 8 different types while another can mean none and all at the same time.